Input IBIS Interface file
Output IBIS Interface file
Integer DATACOL is applicable to both modes.
In the first, it indicates the column number
from which the data values to be moved come
from.
In the second mode, DATACOL indicates the
destination column to which the short col-
umns will be sent.
INDEXCOL specifies, for mode 1, which column
will be used as an index to match the values
specified through the VALUES parameter.
SPECIFYS THE VALUE OF OTHERWISE ZEROED OUT ENTRIES.
VALUES is a list of values to match against
the index column in mode 1. Each time one of
these user-specified values is found in the
index column, the data element corresponding
to the index column entry is moved to the
the column specified by TOCOL which corresponds
to the value number.
TOCOL is the list of columns to which data will
be sent in mode 1. Whenever the index value for
a data element matches one of the values specified
by the user through the VALUES parameter, that piece
of data is moved to a column corresponding to the
value matched.
TOCOL, then, must have the same number of entries
as VALUES.
FROMCOL is relevant to mode 2 only, and indicates
which short columns contain data to be moved to the
column specified by DATACOL.
NCOL is the number of short columns to be processed,
and so is only applicable in the second mode. If
NCOL is less than integer DATACOL, DATACOL columns
will be processed.